Netgear FVS336G-300NAS Specifications download pdf (Page 386)

100

101

Set Up Virtual Private Networking With IPSec Connections

386

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3

Other than the nature of the IP addresses, the settings that you must enter for IPv4 and

IPv6 are identical with one exception. The IPv4 settings require a subnet mask but the

IPv6 settings require a prefix length.

Setting Description

General

Policy Name A descriptive name of the VPN policy for identification and management

purposes.

Note: The name is not supplied to the remote VPN endpoint.

Policy Type From the menu, select a policy type:

• Auto Policy. Some settings (the ones in the Manual Policy Parameters

section) for the VPN tunnel are generated automatically.

• Manual Policy. All settings must be specified manually, including the ones

in the Manual Policy Parameters section.

Select Local Gateway Select a WAN interface from the menu to specify the WAN interface for the local

gateway.

Remote Endpoint Select a radio button to specify how the remote endpoint is defined:

• IP Address. Enter the IP address of the remote endpoint in the

corresponding field to the right of the radio button.

• FQDN. Enter the FQDN of the remote endpoint in the corresponding field to

the right of the radio button.

Enable NetBIOS? Select this check box to enable NetBIOS broadcasts to travel over the VPN

tunnel. This feature is disabled by default.

For more information about NetBIOS, see Configure NetBIOS Bridging with

IPSec VPN on page 419.

Enable RollOver? Select this check box to allow the VPN tunnel to roll over to the other WAN

interface when the WAN mode is set to Auto-Rollover and an actual rollover

occurs. This feature is disabled by default.

Select a WAN interface from the menu.

Enable Auto Initiate Select this check box to enable the VPN tunnel to autoestablish itself without the

presence of any traffic.

Note: For autoinitiation, the direction and type of the IKE policy that is associated

with this VPN policy must be either Initiator or Both but cannot be Responder. For

more information, see Manually Add an IKE Policy on page 371.

1 2 ... 381 382 383 384 385 386 387 388 389 390 391 ... 692 693

Comments to this Manuals

No comments

Netgear FVS336G-300NAS Specifications Page 386

Comments to this Manuals