Netgear WPN824EXT Setup Guide download pdf (Page 20)

16 Installing Your WiFi Range Extender Manually

Verifying Your Connection

Verify that your extender is connected correctly by checking the WiFi range extender status lights,

as described in Figure 10 and the following steps.

To verify that your extender is connected correctly, check the following:

Power. The Power light should be lit.

2. Test. The Test light should be blinking (this indicates that there is no wireless device

connected yet).

3. Wireless. The Wireless light should be blinking (wireless capability is enabled).

4. Internet. The Internet light should be lit (green).

5. LAN. A LAN port light should be lit for the connected computer. Green indicates that your

computer is communicating at 100 Mbps; amber indicates communication at 10 Mbps.

For general information about the status lights, see “Extender Front Panel” on page 3. For help if

the status lights are not as described, see “Basic Functions Are Not Working” on page 26.

Completing Manual Setup

Since you are configuring your WiFi range extender manually, you must log in to your extender to

set up your wireless security. You can also configure other settings there. See “Accessing Your

RangeMax WiFi Range Extender after Installation” on page 17

Figure 10

For information about how to ensure the best performance from your WiFi range

extender, see “Optimizing Performance after Installation” on page 9.











1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

Netgear WPN824EXT Setup Guide Page 20