Netgear 700 Series Managed Switch for Software v2.1 User Manual download pdf (Page 120)

700 Series Managed Switch User’s Guide for Software v2.1

6-30 Command Line Interface

SM-10004-02

Warning: The previous image in non-volatile memory will be lost when the procedure

completes.

• Last Saved option

The system will boot from non-volatile memory. This option will automatically show up after

the ‘Net & save’ option is selected and the unit is reset.

Syntax

FSM726(config)# system firmware boot [net-tftp | net-and-save | last saved]

Firmware TFTP-IP

The Firmware TFTP-IP command is used to specify the IP location of the TFTP server where

the new software image is stored.

Syntax

FSM726(config)# System firmware tftp-ip <IP address>

Where

<IP address> = the IP address of the TFTP server where the new firmware image is stored.

Firmware TFTP-File

The Firmware TFTP-File command is used to specify the path and the filename of the new

firmware image.

Syntax

FSM726(config)# System firmware tftp-file <path&filename>

Where

<path&filename> = the path and the filename of the new firmware image

RADIUS

For enhanced security, you can choose to have authentication done through the RADIUS server if

one is present on your network.

• Authen-Mode

The authen-mode command configures the method in which the user is authenticated.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 151 152

No comments

Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 120