Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 119

  • Download
  • Add to my manuals
  • Print
  • Page
    / 152
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 118
700 Series Managed Switch User’s Guide for Software v2.1
Command Line Interface 6-29
SM-10004-02
Username
Use the username command to create a new user for the switch.
Syntax
FSM726(config)# system username <username>
Where
<username> = the user name you wish to set up for accessing the switch. Please note that this
field is case sensitive.
Password
Use this command to set a password for the switch
Syntax
FSM726(config)# system password <password>
Where
<password> = the password you wish to set for the switch.
Firmware boot
The firmware command is used to upgrade the firmware through a variety of options. The boot
command is used to configure the way in which the switch will boot after a firmware upgrade.
Once the IP address of the TFTP and the path location of the new software image file is properly
configured (Please see section 17 & 18), the user can choose one of three options to boot the
switch after the firmware has been upgraded.
Net option:
This option allows you to try out a new image before upgrading. It requires a TFTP filename
and a server IP address to retrieve the specified image from the given IP address.
The new image will not overwrite the one in non-volatile memory.
Net & save option
This option requires the same setup as the Net option, i.e. TFTP server and a new image.
However, it copies the image to non-volatile memory directly and then the system boots from
non-volatile memory
Page view 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 151 152

Comments to this Manuals

No comments