Netgear 700 Series Managed Switch for Software v2.1 User Manual download pdf (Page 115)

700 Series Managed Switch User’s Guide for Software v2.1

Command Line Interface 6-25

SM-10004-02

Priority

Use the priority command to set the STP priority

Syntax

FSM726(config)# spanning-tree priority <priority>

Where

<priority> = is the STP priority. This number ranges from 0 – 65535.

System

The system command configures important system items such as IP addresses, password security,

and firmware upgrade.

Config-TFTP

The config-tftp command is used to configure and control the mechanism to load or save the

configuration file via TFTP.

Syntax

FSM726(config)# system config-tftp [save | load] <IP address> <path & filename>

Where

[save | load] = Choose save if you wish to save your configuration file to the TFTP server,

load if you wish to load the configuration file from the TFTP server.

<IP address> = the IP of the TFTP server where the configuration file is stored (if you are loading a

configuration file from the TFTP server) or destined for (if you are saving your configuration file

to the TFTP server).

<path & filename> = The path and file name of the configuration file

config-tftp ip

The config-tftp ip command lets you set the IP address of the TFTP server for configuration

file save/load.

Syntax

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 151 152

No comments

Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 115