Netgear 700 Series Managed Switch for Software v2.1 User Manual download pdf (Page 105)

700 Series Managed Switch User’s Guide for Software v2.1

Command Line Interface 6-15

SM-10004-02

<duplex operation> = one of three modes. auto, full, or half.

Exit

This command takes you out of Interface Configuration Mode and back to Configuration Mode.

Syntax

FSM726(config-if)# exit

Flow Control

This command enables flow control on this particular port.

Syntax

FSM726(config-if)# flow-ctrl

Help

The help command displays instructions on how to access help on the CLI.

Syntax

FSM726(config-if)# Help

To access Help on a specific command, you enter a question mark behind the command in

question, then a list of available options will be presented to you. For example, suppose you want

to know the available options to the command

cos. You would enter cos ?.

Mirror

You can designate a port for monitoring traffic from one or more other ports or of a single VLAN

configured on the switch. The switch monitors the network activity by copying all traffic from the

specified monitoring sources to the designated monitoring port, to which a network analyzer can

be attached

Syntax

FSM726(config-if)# mirror [source | monitor]

Where

[source | monitor] = Setting this particular port to be a mirror source or a mirror monitor

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 151 152

No comments

Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 105