Netgear AirCard 875 (all others) User's Guide Page 38

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 37
Supported AT Command Reference
38 2130617
!GSTATUS?
Supporting modems:
All
Returns operational status
This command returns specific details about the current operational status of
the modem.
Parameters:
<ctime>: Current time (Seconds from bootup)
<temperature>: Approximate temperature (5C)
<btime>: Bootup Time (Seconds from reset)
<mode>: Current modem mode
(“POWERING OFF”, “FACTORY TEST”, “OFFLINE”, “ONLINE”,
“LOW POWER MODE”, “RESETTING”, “NETWORK TEST”, “OFFLINE
REQUEST”, “PSEUDO ONLINE”, “Unknown”)
<smode>: System mode acquired by modem
(“No service”, “AMPS”, “CDMA”, “GSM”, “HDR”, “WCDMA”, “GPS”,
“WCDMA+GSM”, “Unknown”)
<PSstate>: Current PS state
(“Attached”, “Not attached”)
<wband>: Current WCDMA band being accessed
(“CDMA cell”, “CDMA PCS”, “IMT2000”, “WCDMA1900”,
“WCDMA1800”, “WCDMA800”, “GSM EGSM900”, “GSM DCS1800”,
“GSM 850”, “GSM1900”, “GPS”, “No band”, “WCDMA900”)
<gband>: Current GSM band, either TCH or BCCH
(“GSM850”, “GSM900”, “DCS1800”, “PCS1900”, “Unknown”)
<wchan>: WCDMA channel number
<gchan>: GSM channel number
<gmmstate>: Current GMM state
(“IDLE”, “DEREGISTERED”, “Registering”, “REGISTERED”,
“Deregistering”, “RA updating”, “Requesting srvc”)
<gmmsubstate>: Current GMM sub-state
(“NORMAL SERVICE”, “LIMITED SERVICE”, “ATT NEEDED”,
“ATTEMPTING ATT”, “NO IMSI”, “NO SERVICE”, “PLMN SEARCH”,
“SUSPENDED”, “UPDATE NEEDED”, “UPDATING”, “DEATACHING”,
“---”)
Note: “---” indicates ‘undefined sub-state’
<mmstate>: Current MM state
(“NULL”, “IDLE”, “LA Rejected”, “LA Start”, “CONNECTED”,
Network Command”, “---”)
Note: “---” indicates ‘undefined state’
<mmsubstate>: Current MM sub-state
(“NORMAL SERVICE”, “LIMITED SERVICE”, “NO IMSI”,
“NO SERVICE”, “PLMN SEARCH”, “UPDATE NEEDED”,
“UPDATING”, “---”)
Note: “---” indicates ‘undefined sub-state’
Table 3-2: Modem status, customization, and reset commands (Continued)
Command Description
Page view 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 75 76

Comments to this Manuals

No comments