Netgear WG111U User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
User’s Manual for the NETGEAR Super AG Wireless USB 2.0 Adapter WG111U
3-4 Basic Setup
202-10065-01
Both of these configuration options are available with the WG111U Wireless USB 2.0 Adapter.
Infrastructure configuration procedures for basic network connectivity are covered below.
Advanced infrastructure configuration procedures and ad-hoc configuration are covered in
Chapter 4, “Configuration” of this manual.
WG111U Default Wireless Configuration Settings
If this is a new wireless network installation, use the factory default settings to set up the network
and verify wireless connectivity. If this is an addition to an existing wireless network, you will
need to identify the wireless configuration and security parameters already defined.
Your NETGEAR Super AG Wireless USB 2.0 Adapter WG111U factory default basic settings are:
Network Name Service Set Identification (SSID): NETGEAR_11g
Note: In order for the WG111U Wireless USB 2.0 Adapter to communicate with a wireless
access point or wireless adapter, all devices must be configured with the same wireless
network name (SSID).
Network Mode (Infrastructure or Ad-hoc): Infrastructure
Data security WPA-PSK: Enabled, Passphrase: NETGEAR-ULTRA-G
The section below provides instructions for setting up the NETGEAR Super AG Wireless USB 2.0
Adapter WG111U for basic wireless connectivity to an access point. The procedures below
provide step-by-step installation instructions for Windows PCs.
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using:
“For Windows XP Users Installing a WG111U” on page 3-5
“For Windows 2000, ME, and 98SE Users Installing a WG111U” on page 3-9
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 107 108

Comments to this Manuals

No comments