Netgear 771S User's Guide Page 103

  • Download
  • Add to my manuals
  • Print
  • Page
    / 205
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 102
Router Settings
Adjust your device’s router settings through the Basic, Port Forwarding, and Port Filtering
tabs.
Enabling VPN Passthrough
If you want to connect to a corporate network using their VPN (Virtual Private Network), you
need to enable VPN Passthrough.
1. Log in to the home page. (See Logging In as an Administrator.)
2. Click Settings > Router > Basic.
3. Beside VPN Passthrough, select On.
4. Click Submit.
UPnP (Universal Plug and Play)
UPnP provides simple and robust connectivity among consumer electronics, intelligent
appliances, and mobile devices from many different vendors. (For more information, see
upnp.org.)
Note: If UPnP is enabled, there are potential security risks.
Enabling UPnP
Before you can use UPnP, you must enable it.
1. Log in to the home page. (See Logging In as an Administrator.)
2. Click Settings > Router > Basic.
3. Next to UPnP, select On.
4. Click Submit.
DHCP
DHCP (Dynamic Host Control Protocol) automatically assigns an IP address to each device on
the network and manages other network configuration information for devices connected to your
network. You do not need to manually configure the IP address on each device that’s on your
network.
The assigned IP addresses are not permanent (as opposed to when using static IP).
Most ISPs (Internet Service Providers) use DHCP.
Normally, you should enable DHCP, in which case you must configure each device on the
network with one of the following:
Device Settings 95
Page view 102
1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 204 205

Comments to this Manuals

No comments