Netgear 597E User's Guide download pdf (Page 31)

Document 2130822. Rev 2 Mar.11 31

7: Technical Specifications

• LED operation

• Radio frequency and

electrical specifications

• Environmental

specifications

This chapter describes the function of the LED, and provides technical

product data for the AirCard ExpressCard.

LED operation

The AirCard ExpressCard has two LED light bars near the antenna end

of the card. The LED light bars operate as follows:

Table 7-1: LED operation

LED State Indicates

Off The card has no power. You have powered off the

card (TOOLS > Power Off Modem), or the card

is not completely inserted into the ExpressCard

slot, or the computer is in suspend mode (which

powers down the card).

Blue, not

blinking

The card has power and is working properly.

Blue, blinking The card’s firmware is being updated. Do not

remove the card.

Amber,

blinking

The card is searching for service.

If this LED state persists, see the online Help (“Not

In Service“).

Amber, not

blinking

An error has occurred. Eject the card (page 18)

and reinsert it.

Off No service is available.

See the online Help (“Not in Service”).

Amber,

blinking

1X coverage is detected. Ready to connect to the

network (click Connect).

Amber, not

blinking

The card is connected to the 1X network, and can

send or receive data.

Blue, blinking 1x-EVDO coverage (Rev. 0 or Rev. A) is detected.

Ready to connect to the network (click Connect).

Blue, not

blinking

The card is connected to the 1x-EVDO network,

and can send or receive data.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 42 43

Comments to this Manuals

No comments

Netgear 597E User's Guide Page 31

Comments to this Manuals